- Dowanload:
- Product Details:
Thank you for purchasing Serwall furniture. We have planned that assembly is a quick and straightforward process with our explicit instruction below so that you can assemble your furniture quickly – even after you have moved to a new home.
Components
Please make sure that all parts (as follows) have been delivered without any damages.
Hardwear & Tools
Be sure check all packing material carefully for small parts that may have come loose inside the carton during shipment.
Missing anything? No worries, submit a request about your missing parts, we will solve your problem in no time.
Assembly Procedure
- Caution: Please do not over-tighten bolts during assembly.
Step 1
- Attach two “Side Stretchers (K)” to”Right Front Leg (E)” and “Right Rear Leg (G)” to create the right leg frame. Use“① M6x60MM Screw” to secure the parts and tighten them with a screwdriver. Repeat the process to create the left leg frame.
Step 2
- Attach “Footrest (J)” to“Left Front Leg (F)” and attach “Back Stretcher (L)” to”Left Rear Leg (H)”. Use “①M6x60MM Screws” and tighten them with a screwdriver.
- Attach “Seat (A)” to the left leg frame.Use“④ M6x70MM Bolt”, “⑤ Washer’and “⑥ Nut” on the front leg and tighten with a “⑦ Wrench” and “⑧ Hex key”, use “② M6x70MM Screw”on the rear leg and tighten with a screwdriver.
Step 3
- Repeat the process on step 2 to assembly the “Footrest (J)”, “Back Stretcher (L)”and “Seat (A)” to the right leg frame.
Step 4
- Attach “Right Arm (C)” to right leg frame and attach “Left Arm (D)” to left leg frame using “① M6x60MM Screw” and tighten them with a screwdriver.
Step 5
- Assembly “Backrest (B)” to the chair frame. Attach the backrest to the seat using “③ M6x80MM Screw’and tighten them with a screwdriver.
- Attach the backrest to the leg frame using“④ M6x70MM Bolt”, “⑤Washer” an”⑥ Nut” on the front leg and tighten with a “⑦ Wrench”and “⑧ Hex key”.
- REPEAT THE STEP 1 TO STEP 5 TO ASSEMBLE THE SECOND BAR CHAIR.
Step 6
- Attach “Connecting Table (M)”to “Chair Arms” to connect 2 bar chairs -Using “⑨M6 x30MM Bolts”, tighten with hand.
- The connecting table can be detached at any time if you wish to move the bar chairs base.
- Using the “⑩ and ⑪” to seal the hole on “Connecting Table (M)”-This is an umbrella hole suitable for most of patio umbrella, you could unseal it to attatch patio umbrella.
Screws, bolts, nuts, and wooden plugs may loosen up during regular use every day. They should be periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause injury. Always check to ensure all hardware and the components mentioned above are attached to the furniture properly and kept tightened at all times.